When you want cubes of winter squash for a dish, go for butternut because of its high yield (flesh to seed ratio) and its ease of handling. Because winter squashes are hard, they are difficult to cube, so most of the oddly shaped ones end up baked, with the cooked flesh scooped out with a spoon. Butternut is the easiest of all to cut because the neck is smooth and solid flesh. Still, without a plan, they can be difficult to work with. Here are the basics of cubing a butternut.
 |
| 1. Cut out the Neck |
For butternut squash that you are going to cube, try to buy ones with necks that are roughly the same diameter from the top down to the bell. Cut off the top where the squash attaches to the vine, cutting straight across. Likewise, on the other end slice straight through to cut off the bell that contains the seeds. Reserve the bell for soup or some other application. It is good squash, but because of its shape, it will not cube well.
 |
2. Peel the Neck
|
Stand the neck vertically and using a knife (serrated works wonders for this), peel off the rind in strips.
 |
3. Slice off a Slab to Make a Stable Base
|
The trick to safely cutting any odd-shaped foodstuff is to make yourself a flat, stable base that you can lay on your cutting board. A flat surface will not rock when you cut. This is critical with hard foods such as winter squash where you are going to have to use a little muscle to make the cut.
In the photo, you see that I took a slab off the side. The safest way to make this cut is with the neck standing vertically. If you try to make it with the squash laying horizontally on the cutting board, be very careful that it does not rock.
 |
4-5. Slab and Cut into Strips
|
Rotate the barrel of the squash so that the now-flat side is down against the cutting board. Continue to cut it into slabs the width of the cubes that you want to make.
Once you have cut the squash into slabs, cut each slab into strips the width of the cubes that you want to make. Once you get the hang of it and are confident about your knife work, you can stack two or three slabs before cutting strips, as long as the stacked slabs are stable and do not rock.
 |
6. Cut into Cubes
|
The last step is to gather as many strips as you feel comfortable cutting at one time and make the final cuts to turn them into cubes.
No comments:
Post a Comment